Mounting Options

deSIGNery Signs has been designing and selling  for more than 29 years.
29

Acrylic Flat Cut Mounting Options



Image of 2a-stud mounting for Formed Plastic Letters

2A-Stud

Image of 2b-pad mounting for Formed Plastic Letters

2B-pad

Image of 2c-combination mounting for Formed Plastic Letters

2C-Combo

Image of 2d-combination-all mounting for Formed Plastic Letters

2D-Combo-All

Image of 2f-flange mounting for Formed Plastic Letters

Flush Stud

Image of foam-filled mounting for Formed Plastic Letters

Foam Tape


1A-PLAIN MOUNT Letters with no mounting hardware, Laminated Letters can be attached to mounting surface with a combination of adhesive or double-faced tape – applied by installer – based on surface and letter weight.

2A-STUD MOUNT Stud blocks are solvent bonded to letter backs to receive a stud. These blocks will require the letters to stand-off the mounting surface approximately 3/8” - 1/2”. Drilling patterns are required for this installation.

FLUSH-STUD MOUNT Thicker letters (min. 3/8” thick) can be drilled and tapped for stud installation. Specify if studs need to be in line for brick / block mortar joints or rails.

2B-PAD MOUNT Letters are supplied with plastic pads on the backs of letters. Secure the letters to the wall by using a spacing tape guide and silicone adhesive. Adjustable or flush pads available upon request. Pads are plastic disks on the rear of the letters. Secure the letters to the wall using a split stencil pattern or spacing tape guide and silicone adhesive. Adjustable pads available upon request. Letters to stand-off the mounting surface approximately 3/8” - 1/2”.

2C-COMBINATION MOUNT Combination of studs and pads. Stud through a pad on the top portion of each letter, pads only on the bottom portion of each letter. Mounting procedure is the same as a Stud Mount with the addition of securing pads to the mounting surface with adhesive. Studs can be aligned in-line for brick or block mortar upon request. Letters to stand-off the mounting surface approximately 3/8” - 1/2”. Drilling patterns are required for this installation.

2D-COMBINATION ALL MOUNT Stud through a pad on the top and bottom portion of each letter. Mounting procedure is the same as a Stud Mount. Studs can be aligned in-line for brick or block mortar upon request. Letters to stand-off the mounting surface approximately 3/8” - 1/2”. Drilling patterns are required for this installation.

DOUBLE FACED TAPE MOUNT Partial covered backs with a VHB, double faced tape. Volume of tape is based on letter size and gauge. Heavier letters may require tape and adhesive (such as epoxy on acrylic). VHB tape is designed for interior, flat, dry wall installations. Secure the letters to the wall using a stencil pattern.